Home
>
PRODUCTS
>
Steel Pipe Steel Tube
>
A hydraulic cylinder tube is bought on the inside diameter, not the outside. The bore has to hold tolerance along the full stroke, the surface has to seal against a polyurethane or PTFE rod seal, and the wall has to be uniform enough that the honing tool does not break through into a thin section. This GB/T3639 cold drawn tube is produced from grade 20# seamless hollow, cold drawn to near final size, then honed to an H8 or H9 bore with a surface roughness of Ra 0.2 to 0.4 micrometres.
Cold drawing rather than machining is what makes the economics work: the drawing pass reduces the wall by 15 to 25 percent and improves dimensional accuracy and surface finish at the same time, so the honing allowance is small and the material loss is low. Tubes can be supplied in the cold drawn plus stress relieved condition, which is what most cylinder makers want because it holds straightness and dimension through subsequent welding of the end caps.
Key Features| Parameter | Specification |
|---|---|
| Product | Cold drawn precision steel tube, honed |
| Standard | GB/T3639, EN 10305-1, ASTM A519 on request |
| Grade | 20#, 45#, Q345B, CK20, S20C, E355 |
| Outside diameter | 16 mm - 200 mm |
| Wall thickness | 1.5 mm - 20 mm |
| Inside diameter tolerance | H8, H9, or to drawing |
| Bore roughness | Ra 0.2 - 0.4 micrometre |
| Concentricity | 0.05 mm typical |
| Straightness | 1 mm per metre maximum |
| Delivery condition | Cold drawn, stress relieved (+SR) |
| Length | up to 6 m, cut to order |
| Test | Dimensional, roughness, hydrostatic on request |
The primary use is hydraulic cylinder barrels for construction machinery, agricultural equipment, forklifts, press brakes, injection moulding machines and marine hydraulics. The same tube is used for pneumatic cylinders, shock absorber bodies, precision shafts and rollers where a ground or honed surface is needed.
If the cylinder will be welded, specify the stress relieved condition and tell us the welding process. Welding on cold drawn tube without stress relief can distort the bore, and re-honing after welding adds cost that is avoidable with the right delivery condition. For cylinders operating above 200 bar, we also recommend confirming the wall against the calculated hoop stress rather than selecting on outside diameter alone.
Inspection, Documentation and PackagingEach lot is checked for outside diameter, inside diameter by air gauge, wall thickness by ultrasonic, straightness on a surface plate, and bore roughness with a profilometer. Hydrostatic testing can be performed on finished tubes at the working pressure specified by the buyer, and salt spray or corrosion testing is available for the external surface treatment.
Tubes are oiled internally, capped at both ends and packed in wooden cases with separators so the honed bores never touch. Case weights are matched for forklift handling, and each case is marked with size, bore tolerance, heat number and quantity for direct issue to the assembly line.
Buyer Questions We Answer Before OrderingCan you hone to a specific roughness rather than a range? Yes, we can target Ra 0.2, 0.3 or 0.4 and report the measured value per lot against your limit.
Do you supply SKIVED and roller burnished tube? Yes, skiving and roller burnishing is available as an alternative to honing for long cylinders, with a comparable surface finish.
What is the minimum order for a non-standard bore? Non-standard bores are produced to order with a practical minimum of about 3 tons per size.
Contact Us at Any Time