Home
>
PRODUCTS
>
Steel Pipe Steel Tube
>
Prefabricated housing puts a specific demand on square tube: the corners must be square enough to close a panel joint, and the galvanized surface must survive handling, transport and a season on site without red rust creeping out of the weld. This 100 x 100 x 4 mm square hollow section is formed from pre-galvanized coil or hot dipped after forming, depending on the coating life the project asks for, and it is produced to ASTM A500 Gr.B with a controlled corner radius between 6 and 10 mm.
Square and rectangular sections are the structural workhorse of modular building. A 100 x 100 x 4 mm tube carries roughly 40 kN in pure compression over a 3 m storey height, which is why it appears in container house corner posts, mezzanine legs and roof purlins. We keep the wall thickness on the heavy side of tolerance rather than the light side, because a tube that gauges 3.6 mm instead of 4.0 mm loses about ten percent of its section capacity and the frame design may no longer close.
Key Features| Parameter | Specification |
|---|---|
| Product | Galvanized square hollow section |
| Standard | ASTM A500 Gr.B, EN 10219, GB/T 6728 |
| Section | 100 x 100 mm |
| Wall thickness | 4.0 mm (3.0 - 6.0 mm available) |
| Length | 6 m standard, 12 m or cut length on request |
| Corner radius | 6 - 10 mm |
| Zinc coating | Pre-galvanized 60 - 100 g/m2, hot dipped 275 g/m2 |
| Yield strength | 290 MPa minimum (A500 Gr.B) |
| Tensile strength | 400 MPa minimum (A500 Gr.B) |
| Straightness | 1.5 mm per metre maximum |
| Twist | 1 degree per metre maximum |
| Ends | Square cut, burr removed |
Modular and container houses, site offices, guard booths, prefabricated toilets and shower units use this section for corner posts, floor bearers and roof frames. It is equally common in mezzanine floors, racking, fence posts, gate frames, solar mounting and greenhouse structures, and in exhibition stands where the visible surface has to look clean after repeated assembly.
When the tube will be welded on site, specify hot dipped rather than pre-galvanized. Welding burns the zinc back 10 to 20 mm from the bead, and on a pre-galvanized tube that leaves a thin band of unprotected steel that rusts first. For bolted modular systems the pre-galvanized coil product is usually sufficient and costs less.
Inspection, Documentation and PackagingInspection covers section dimensions at both ends, wall thickness at four points per length, corner radius, straightness, twist and coating mass. Welds are checked visually and by flattening test on samples from each lot, and the zinc coating is checked for adhesion by a bend test around a mandrel.
Tubes are bundled by size and wall thickness, strapped at 1.5 m intervals, with cardboard or plastic corner protection so the galvanized faces are not scuffed in transit. Bundles are marked with heat number and bundle number, and the packing list repeats the fabrication cut lengths so the site can allocate bundles directly to frames.
Buyer Questions We Answer Before OrderingCan you supply 100 x 50 and 100 x 100 in the same container? Yes, square and rectangular sections are bundled separately and loaded together, and we can match the bundle weights to the container payload limit.
Is the tube suitable for direct ground contact? For posts in soil we recommend hot dipped 275 g/m2 and a sealed bottom cap. Pre-galvanized tube is not intended for buried service.
Do you cut to length for modular panels? Yes, we cut to your panel length with a tolerance of plus or minus 2 mm and can drill or notch to drawing.
Contact Us at Any Time