Home
>
PRODUCTS
>
Steel Pipe Steel Tube
>
A 50 x 150 rectangular hollow section is chosen when the load runs one way. Used on edge, it puts material where the bending stress is, so a 4.5 mm wall gives a section modulus that a 100 x 100 square tube cannot match at the same weight. That is why this size appears in roof purlins, trailer frames, racking beams and mezzanine joists, where the depth does the work and the narrow face keeps the profile out of the way.
The tube is roll formed from hot rolled or galvanized coil, welded by high frequency induction, sized and straightened, then hot dipped where the order requires a 275 g per square metre coating. Section tolerances follow ASTM A500: outside dimensions within plus or minus 1 percent, wall within plus or minus 10 percent, and corner radius held between 6 and 10 mm. For frame work the important number is usually straightness, so we hold it under 1.5 mm per metre and check twist separately.
Key Features| Parameter | Specification |
|---|---|
| Product | Galvanized rectangular hollow section |
| Standard | ASTM A500 Gr.B, EN 10219, GB/T 6728 |
| Section | 50 x 150 mm |
| Wall thickness | 4.5 mm (3.0 - 6.0 mm available) |
| Length | 6 m standard, 12 m or cut to order |
| Corner radius | 6 - 10 mm |
| Zinc coating | Hot dipped 275 g/m2, pre-galvanized 60 - 100 g/m2 |
| Yield strength | 290 MPa minimum |
| Tensile strength | 400 MPa minimum |
| Straightness | 1.5 mm per metre maximum |
| Twist | 1 degree per metre maximum |
| Ends | Square cut, beveled on request |
Applications include roof purlins and side rails on steel buildings, mezzanine floor joists, trailer and truck body frames, racking beams, machine bases, agricultural equipment frames and architectural canopies. The narrow 50 mm face is useful where a frame has to sit inside a wall cavity or behind a cladding line.
For welded frames that will be galvanized after fabrication, specify hot dipped material with the weld seam left continuous and vent holes drilled at each closed end. For bolted assemblies, pre-galvanized is usually adequate and saves coating cost. If the section will be exposed to coastal air, we suggest 275 g/m2 minimum and stainless fasteners rather than galvanized bolts.
Inspection, Documentation and PackagingChecks include section dimensions, wall thickness at both ends, corner radius, straightness, twist and visual weld inspection, with flattening and bend tests on lot samples. Coating mass is verified on hot dipped lots by the stripping method and the result is recorded in the inspection report.
Tubes are bundled by section and wall, strapped at 1.5 m intervals, with corner protection to avoid scuffing the zinc. Bundle weights are matched to the container payload, and the packing list carries cut length, heat number and bundle count so the fabricator can allocate material without re-measuring.
Buyer Questions We Answer Before OrderingCan you supply 50 x 100 and 50 x 150 together? Yes, we bundle each section separately and load them in the same container, with a combined packing list.
What is the lead time for a cut-to-length order? Cutting and drilling adds three to five working days on top of the standard 10 to 20 day production window.
Is the inside of the RHS coated? Yes, hot dipping covers the internal surface. Pre-galvanized coil leaves the internal weld area with a thinner coating, which is why we recommend hot dipped for corrosive service.
Contact Us at Any Time