Home
>
PRODUCTS
>
Steel Pipe Steel Tube
>
PSL2 is where line pipe stops being generic pipe. Under API 5L PSL2 the chemistry is restricted further, carbon equivalent is capped, tensile properties are tested per lot, and a Charpy impact test is mandatory rather than optional. This X52 seamless pipe at 323.9 mm outside diameter and 9.53 mm wall is a 12 inch Sch40 transmission size, supplied beveled for field girth welding and documented for pipeline service.
The practical difference on site is weldability and toughness. X52 PSL2 with a controlled carbon equivalent of 0.43 maximum welds predictably with cellulosic or low hydrogen electrodes, and the impact requirement gives the pipeline resistance to brittle fracture propagation at low ambient temperature. Each heat is tested for yield, tensile, elongation and impact, and the results appear per heat number on the EN 10204 3.1 certificate, which is what a pipeline operator's third party inspector will ask for.
Key Features| Parameter | Specification |
|---|---|
| Product | Seamless line pipe |
| Standard | API 5L PSL2, ISO 3183 |
| Grade | X52 / L360 |
| Outside diameter | 323.9 mm (12 inch) |
| Wall thickness | 9.53 mm (Sch40) |
| Length | 11.8 - 12 m, SRL and DRL available |
| Yield strength | 359 - 499 MPa |
| Tensile strength | 518 - 760 MPa |
| Carbon equivalent | 0.43 maximum |
| Impact test | 27 J minimum at 0 degrees C, lower temperature on request |
| Ends | Beveled 30 degree, plain end available |
| Coating | Bare, 3PE, FBE, or coal tar enamel |
This pipe is used for crude and product transmission lines, gas gathering and distribution mains, water injection lines and pipeline replacements in the oil and gas sector. The 12 inch Sch40 size is common in medium pressure trunk lines and in station piping where a heavier wall than Sch20 is specified for mechanical strength.
For sour service to NACE MR0175 the specification changes: hardness must be limited, sulphur reduced and the steel may need to be normalized or quenched and tempered, so a standard X52 PSL2 heat cannot simply be substituted. Tell us the H2S partial pressure and the design code at enquiry stage and we will quote the correct product rather than a near equivalent.
Inspection, Documentation and PackagingTesting follows the API 5L PSL2 frequency: tensile and yield per lot, Charpy impact per heat and lot, dimensional inspection on both ends, and hydrostatic testing of every length. Non-destructive inspection of the pipe body and ends is available with ultrasonic and eddy current methods, and a hardness survey can be added for sour service evaluation.
Beveled ends are coated with a rust preventive that is compatible with field welding and protected with plastic caps or steel end rings. Bundles are strapped and separated with wooden dunnage so bevels never contact each other, and each bundle carries a tag with heat number, size, length and weight for pipeline tally.
Buyer Questions We Answer Before OrderingCan you supply 3PE coated pipe from the same heats? Yes, coating is applied after the pipe passes inspection, and we keep the heat number through the coating process so the certificate remains traceable.
Do you provide a separate NDT report? Yes, ultrasonic and eddy current reports are issued separately from the mill certificate, with the inspector's identification.
What is the minimum order for a non-standard wall? Non-standard walls are rolled to order, with a practical minimum of about 20 tons per size.
Contact Us at Any Time