Home
>
PRODUCTS
>
Steel Pipe Steel Tube
>
Boiler tube is bought on minimum wall, not average wall. A tube ordered at 3.5 mm average wall can legally contain sections at 3.1 mm, and that is where a superheater fails after a few thousand thermal cycles. Our A192 and A179 boiler tube is produced and certified to minimum wall, so the thinnest point of every length is at or above 3.5 mm, and wall thickness is verified by ultrasonic measurement along the full length rather than at the ends only.
A179 covers low carbon steel heat exchanger and condenser tubes with a minimum wall requirement, while A192 covers seamless carbon steel boiler tubes for high pressure service with tighter chemistry and a mandatory hydrostatic test. Both are supplied here at 51 mm outside diameter, 3.5 mm minimum wall and 11.8 m length, with 100 percent eddy current testing to detect longitudinal and transverse defects before the tube goes into a boiler bank.
Key Features| Parameter | Specification |
|---|---|
| Product | Seamless carbon steel boiler tube |
| Standard | ASTM A192, ASTM A179, ASME SA192, SA179 |
| Outside diameter | 19 mm - 133 mm |
| Wall thickness | 2.0 mm - 12 mm, minimum wall control |
| Length | 11.8 m, 6 m, or cut to order |
| Grade | A192, A179, A210 Gr.A1 / C |
| Tensile strength | 325 MPa minimum (A179), 415 MPa minimum (A192) |
| Yield strength | 180 MPa minimum (A179), 255 MPa minimum (A192) |
| Test | Hydrostatic and 100 percent eddy current |
| Surface | Bare, pickled, or black varnished |
| Ends | Plain, beveled, or swaged |
| Packing | Hexagonal bundle with end caps and waterproof wrap |
Applications are superheater and reheater tubes, economiser coils, water wall panels, boiler bank tubes, feedwater heaters and heat exchanger bundles in power stations, waste heat recovery boilers and industrial steam plants. A179 is used where the tube sees lower temperature but must still hold a minimum wall, while A192 is specified for higher pressure boiler service.
Replacement tube orders are usually urgent, so we keep common sizes of A179 and A192 in stock and can ship cut lengths within a week. Send the original tube drawing or the boiler manufacturer's part number and we will match the outside diameter, minimum wall, length and end preparation instead of quoting the nearest standard size.
Inspection, Documentation and PackagingInspection includes chemistry per heat, tensile and yield per lot, flattening and flaring tests, hardness, hydrostatic testing of every length and 100 percent eddy current testing along the full length. Wall thickness is measured ultrasonically at intervals along the tube, and the minimum reading is recorded on the certificate for each bundle.
Tubes are bundled hexagonally, capped at both ends, wrapped in waterproof paper and protected with wooden or plastic end rings. For U-bent tubes we use stack-rack boxing with the bend radius supported, because an unsupported U-bend will ovalize in transit and the tube will not pass the plug gauge on site.
Buyer Questions We Answer Before OrderingDo you certify minimum wall or average wall? Minimum wall. The certificate reports the lowest measured wall per bundle, and the ultrasonic records are available on request.
Can you bend the tubes to our radius? Yes, through qualified bending shops with eddy current testing before and after bending and stress relief annealing after bending.
How fast can you ship replacement tubes? Common A179 and A192 sizes ship within 7 to 10 days from stock; non-stock sizes take 15 to 25 days.
Contact Us at Any Time