Home
>
PRODUCTS
>
Steel Pipe Steel Tube
>
Large diameter pipe is a logistics problem as much as a metallurgy one. A 1220 mm spiral welded pipe gives you transmission capacity that no seamless mill can produce economically, and the spiral seam lets the mill roll a wide coil into a large diameter without the tooling change that a straight seam mill would need. This pipe is produced to SY/T5037 in Q235B, with a 12 mm wall and a 12 m length, appropriate for water transmission, drainage, slurry and low pressure process lines.
The governing risk in spiral pipe is the seam, so that is where the inspection effort goes. The pipe is welded inside and outside by submerged arc welding, with the internal weld made first and the external weld following, and the seam is checked by visual inspection, ultrasonic or radiographic testing according to the inspection level the buyer specifies. We can supply at three inspection levels so a drainage line does not pay for pipeline grade radiography while a trunk main still gets the testing it needs.
Key Features| Parameter | Specification |
|---|---|
| Product | Spiral welded steel pipe |
| Standard | SY/T5037-2018, GB/T 9711, API 5L on request |
| Outside diameter | 219 mm - 3048 mm |
| Wall thickness | 5 mm - 25 mm |
| Length | 6 m - 12 m |
| Steel grade | Q235B, Q345B, L245, L290 |
| Weld type | Double sided submerged arc welding |
| Yield strength | 235 MPa minimum (Q235B) |
| Tensile strength | 375 - 500 MPa (Q235B) |
| Test | Hydrostatic, ultrasonic or radiographic weld inspection |
| Ends | Square cut, beveled, or spigot and socket |
| Coating | Bare, epoxy, 3PE, cement mortar lining |
Typical uses are raw and treated water transmission mains, drainage and sewage lines, cooling water intake and outfall, slurry pipelines, piling tubes for port and bridge works, and structural columns in large span buildings where a concrete filled steel tube is specified.
On site, the main failure mode is not the pipe body but the field joint. For cement mortar lined pipe we leave the ends unlined by 100 to 150 mm so the field weld is not contaminated by lining, and we mark the lining stop line on the pipe. If the pipeline will carry potable water, specify a lining and coating system with a potable water approval instead of a standard epoxy, because the certificate is checked at commissioning.
Inspection, Documentation and PackagingThe coil is checked for grade and thickness, the spiral forming angle and weld gap are monitored continuously, and the seam is inspected by ultrasonic or radiographic methods according to the agreed level. Dimensional checks cover outside diameter, ovality, wall thickness, length and end squareness, followed by hydrostatic testing of every length.
Pipe is loaded loose or bundled depending on diameter, with wooden dunnage between layers and the ends protected against impact. Larger diameters are lifted with fabric slings at marked lifting points. We supply a loading plan with bundle or piece numbers and weights so the receiving site can plan crane capacity before the vessel arrives.
Buyer Questions We Answer Before OrderingCan the pipe be supplied with cement mortar lining? Yes, cement mortar lining to AWWA C205 or a local standard is applied at a qualified plant, with the field joint area left unlined.
What is the maximum diameter you can produce? Up to 3048 mm outside diameter, with wall thickness matched to the diameter and the internal pressure requirement.
Do you provide radiographic testing on the seam? Yes, at the buyer's specified percentage. Full length radiography is expensive, so most water projects specify 10 to 20 percent sampling plus ultrasonic.
Contact Us at Any Time